Why doesn't my
AGP video card fit in the AGP slot?The
system AGP slot is for AGP
4X, 1.5V compliant video cards only.
Older AGP video cards will not fit because it does not operate at 1.5V. The only
solution is to upgrade your existing AGP video card to one that is 4X and 1.5V
compliant.
How do I enable ATA-100 IDE support?
You need an IDE HDD that is ATA-100 compliant. In addition, make sure the IDE cable (40 pin, 80 conduct) you're using is also ATA-100 compliant.
My HDD is not ATA-100, can I still use it?
Yes, the onboard IDE controller is downwardly compatible with PIO, DMA, ATA-33, or ATA-66 HDDs.
I've turned the system on, but I'm getting no power (i.e., power supply fan does not spin).
Make sure the cable from the case's power switch is connected properly to
the board's power on jumper; refer to the motherboard manual. Try reseating the ATX power connector to the motherboard.
Disconnect all the power connectors to your HDD, FDD, CD-ROM, etc. then
try powering the system up. Try replacing the ATX power supply.
I have two USB ports in the back, how do I enable them?
Windows NT 4.0 currently do not support USB. Windows 98/98SE, Windows 2000, Windows
Millennium Edition (
come with native USB drivers.
What kind of D
IMMs can I use?
Use PC133 SDRAM DIMMs. ECC or non-ECC.
Can I use just one
DIMM?
Yes.
Can I mix ECC and non-ECC DIMMs?
Yes, the system memory
will function in non-ECC mode if one of the slot is filled with non-ECC memory.
What is the system's maximum memory capacity?
It is 2GB using three 2GB DIMMs.
Top of page
Operating System Specific Questions
I have an Unknown Device in Device Manager under Windows 9x, ME, or W2K.
You may need to install the
Intel Chipset INF update.
Do you have a troubleshooting guide for Windows 98/98SE?
Yes, we do; please see Premio Windows 98/98SE Troubleshooting Guide.
Do you have a troubleshooting guide for Windows 2000?
Yes, we do; please see Premio Windows 2000 Troubleshooting Guide
