to 2-3 and leave it there for 2 or
3 seconds. Move JBAT1 back to 1-2 and power up your system.
I have flashed my BIOS, but now I get no video!
Try clearing your CMOS (see above). Make sure you've flashed the BIOS using the
correct BIOS for your system board; flashing the wrong BIOS will render the
board inoperable.
Top
of page
Hardware Questions
I'm trying to add a serial ATA (SATA) HDD to my system, but it is not detecting it.
Go into the BIOS setup and go to Integrated Peripherals / On-Chip
IDE Configuration. Set the On-Chip ATA(s) Operate Mode to
Native Mode, and ATA Configuration to P-ATA + S-ATA
How do I disable the onboard audio?
Go into the BIOS setup and go into Integrated Peripherals and set
the AC'97
Audio option to disabled.
I've turned the system on, but I'm getting no power (i.e., power supply fan does
not spin).
Make sure the cable from the case's power switch is connected properly to the
board's power on jumper; refer to the motherboard manual. Try reseating the ATX
power connector to the motherboard. Disconnect all the power connectors to your
HDD, FDD, CD-ROM, etc. then try powering the system up. Try replacing the ATX
power supply.
What kind of DDR D
IMMs can
I use?
Use PC3200/DDR400, non
ECC, unbuffered, and
non-registered
DIMMs.
